Thermal Insulation Coatings is Elastomeric Thermal Insulation and Water proof coating. After curing it forms heat barrier, flexible, and strong film which bridges cracks, prevents peeling, future cracks, growth of algae or fungi. It prevents water seepage and is UV resistant.

Insulmix HR is designed for use on almost all surfaces. Exterior R.C.C. surface, Cement surfaces, Asbestos sheets, G.I. sheets, Galvalum sheets, Stone walls, Sloping roofs, wood, plastic, for ovens and furnaces, freezer vans, mobile houses, Industrial and Commercial facilities, Special application in defense, cold storage, automobiles, and places requiring thermal insulation and waterproofing.

INSULMIX T.I.C. is one coating, which works as exterior/interior paint, U V Resistant coating, waterproofing and most importantly thermal insulation coating and eliminates conventional waterproofing, and thermal insulation of the building.

Insulmix EP helps to block transfer of heat inward when applied to exterior of walls and outward when applied to interior of walls. For maximum electricity savings in air conditioned buildings, we recommend doing both! Advantages. Reduction of electricity cost by upto 40%

This product is used to the surface of furnace where the temperature is more than 900 degrees C and less than 1100 degrees C. This blocks radiation losses by repelling it interior and helps even heating throughout furnance. This in turn provides saving up between 10%. - 20%.  This is used for reduction in energy consumption of furnaces due to heat losses.

For achieving heat resistant with thermal insulation of surfaces up to 350 Deg C. P.U.S.I Composite H.R.T.I 400 is used. It is mainly suggested for Furnace, Boilers, Freezer vans, ovens up to 400 degrees C or any surface needing heat insulation, rubber moulds, presses, plastic moulds and presses to achieve energy saving through blocking heat losses from moulds. 

​

For achieving heat resistant with thermal insulation of surfaces up to 550 Deg C H.R.T.I 600 is used.. This is mainly used for rubber moulds, presses, plastic moulds and presses to achieve energy saving through blocking heat losses from moulds.. HRTI 600 is mainly suggested for Chimneys,Furnace, Boilers, Freezer vans, ovens up to 400 degrees C or any surface needing heat insulation.

Excellent Product for Energy Saving Coating Upto 1200 Deg C Solvent Base. Thermal Insulation Coatings is the only product which takes the care of radiation. This product is also suitable for brick hangers in furnace ceiling, furnace doors, any metal area behind bricks which can be exposed to excessive heat in case of bricks being damaged or leaked through.

This product is used to the surface of boiler where the temperature is more than 600 degrees C and less than 1100 degrees C,  This is suitable product for application on metal surfaces. For application over bricks, our water base product should be used.

The Product is mainly used for reducing the surface temperatures of hot surfaces like Exterior of hot oil tanks, furnaces & boilers. Approximately 30 to 50 mm thick coating is to be applied depending upon the surface temperature.  This is also used for reducing the surface temperatures of steam lines, hot water lines, hot gasses lines, hot oil lines etc.